WIRING Pg 31-04

5/6 Back to spaghetti routing...Starting on Step 10, we separated the colors according to the directions. It really helps to take one SENTENCE at a time, as there is so much information in regards to color of the individual wires. No problems on page 4 or 5; just make sure you have the tabs pointed in the correct direction on the F-1207B Assembly. On page 6, we installed the magnets in the handles of the WD-1217, but we sawed off about 3/8 of an inch to make the magnets function. We tested them with a continuity tester. We put in a couple of 'hidden' snap bushings that would have been easier to install if we had them earlier in the construction process. We had the autopilot harness on backorder, from page 7, so we had to wait until it arrives to finish that part of the wiring, and that took us ovr to page 9, step 7. We went over to page 10, and stopped at step 7. We had a little problem in installing the headphone jacks, in that we had to add a couple of washers to make the jacks 'grab' onto the metal.
No photos for this set.